Adjusting line misalignment – Canon imagePROGRAF TM-300 36" Large-Format Inkjet Printer with L36ei Scanner Kit User Manual
Page 368
Adjusting Line Misalignment
If printed lines are misaligned, execute
Print head angle adjustment
to adjust the print head angle.
head angle adjustment
requires you to examine a printed test pattern and adjust the angle using the angle
adjustment lever.
Always adjust the print head angle after replacing the print head.
Important
• Because the results of adjustment vary depending on the type of paper used for adjustment, use the
same type of paper as you will use for printing.
• When using cut sheets, do not move the release lever until instructions (guidance) for removing the
paper are displayed.
Moving the release lever during printing or maintenance operations will cause the printer to stop.
Paper to Prepare
When using rolls
An unused roll at least 10.00 inches (254.0 mm) wide
When using sheets
One sheet of unused paper of at least A4/Letter size
Perform adjustment as follows.
1.
Load paper.
Loading Rolls on the Roll Holder
Loading Rolls in the Printer
Loading Sheets in the Printer
Important
• Always make sure the loaded paper matches the type of paper specified on the printer.
Adjustment cannot be completed correctly unless the loaded paper matches the settings.
2.
Tap
(Setup) >
Maintenance
on HOME screen.
The
Maintenance
screen appears.
3.
Tap
Print head angle adjustment
.
A confirmation message appears.
4.
Tap
Yes
.
The carriage moves and the guidance for the print head angle adjustment procedure appears on the
touch screen.
368