Canon imagePROGRAF TM-300 36" Large-Format Inkjet Printer with L36ei Scanner Kit - Manual (Page 157)

LAN settings
This setting item is displayed by tapping Device settings after tapping ( Setup ) on the HOME
screen.
Important
• The administrator password is required to change settings if it is enabled for changing settings using
the operation panel.
Note
• You can also enter LAN settings by tapping ( Network ) on the HOME screen.
• Wi-Fi
The following setting information on the Wi-Fi connection is displayed. (Some items are not displayed
depending on printer settings.)
Items Setting
Connection Enabled (connected) / Enabled (disconnected) / Disa-
ble
Network name (SSID) XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX (up to 32 characters)
Communication mode Infrastructure
Channel 1 - 13
Wi-Fi security Disable / WEP (64 bit) / WEP (128 bit) / WPA-PSK
(TKIP) / WPA-PSK (AES) / WPA2-PSK (TKIP) / WPA2-
PSK (AES)
IPv4 address XXX. XXX. XXX. XXX (12 characters)
IPv4 subnet mask XXX. XXX. XXX. XXX (12 characters)
IPv4 default gateway XXX. XXX. XXX. XXX (12 characters)
IPv4 DNS dynamic setting Enable / Disable
IPv4 DNS host name XXXXXXXXXXXX
IPv4 DNS domain name XXXXXXXXXXXX
IPv6 link-local address XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
IPv6 link-local prefix length XXX (up to 3 digits)
IPv6 manual address XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
IPv6 manual prefix length XXX (up to 3 digits)
IPv6 stateless address 1 XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
157