Canon imagePROGRAF TM-300 36" Large-Format Inkjet Printer with L36ei Scanner Kit - Manual (Page 206)

Width correction
Corrects pen widths in accordance with a specific correction setting. Correction settings can be configured
for two groups:
Black/gray and Color .
Select and apply the correction amount according to the pen color when performing a line drawing
command of HP-GL/2 data.
This setting item is displayed by tapping in the following order.
( Setup ) > Device settings > Print settings > HP-GL/2 print settings > Line & pen manager
Note
• This setting is not applied for the white pen, which has the same RGB values (255).
• This setting is applied to vector data line widths.
• When this setting is a minus value, it is not applied to fine lines of widths that are less than the minimum
line width of the printer.
• If the setting value is smaller than 1 dot, the value of 1 dot width is applied.
• When
ON is selected for Thicken fine lines , the resulting line may be thicker than the specified setting.
• Black/gray
For configuring the correction setting of black and gray line widths.
A value within the range of -20 to +20 can be specified. 1 unit of the correction value is equivalent to
0.025 mm.
• Color
For configuring the correction setting of color line widths.
A value within the range of -20 to +20 can be specified. 1 unit of the correction value is equivalent to
0.025 mm.
LINE WIDTH CORRECTION EXAMPLE
• Negative (-) setting
• Positive (+) setting
206