PLANET XGS3-24042 - Manual (Page 971)

48-7
Default:
dot1x address filter is disabled by default.
Usage Guide:
When dot1x address filter function is enabled, the switch will filter the authentication user by the
MAC address. Only the authentication request initialed by the users in the dot1x address filter table
will be accepted.
Example:
Enabling dot1x address filter function for the switch.
Switch(config)#dot1x macfilter enable
48.10 dot1x max-req
Command:
dot1x max-req <count>
no dot1x max-req
Function:
Sets the number of EAP request/MD5 frame to be sent before the switch re-initials authentication on
no supplicant response; the “no dot1x max-req” command restores the default setting.
Parameters:
is the times to re-transfer EAP request/ MD5 frames, the valid range is 1 to 10.
Command mode:
Global Mode.
Default:
The default maximum for retransmission is 2.
Usage Guide:
The default value is recommended in setting the EAP request/ MD5 retransmission times.
Example:
Changing the maximum retransmission times for EAP request/ MD5 frames to 5 times.
Switch(config)#dot1x max-req 5
48.11 dot1x user free-resource
Command:
dot1x user free-resource
no dot1x user free-resource