PLANET XGS3-24042 - Manual (Page 508)

33-147
Exit address-family mode
Command Mode:
address-family mode
Example:
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf IPI
Switch(config-router-af)# exit-address-family
Switch(config-router)#
33.12 ip rip aggregate-address
Command:
ip rip aggregate-address A.B.C.D/M
no ip rip aggregate-address A.B.C.D/M
Function:
To configure RIP aggregation route. The no form of this command will delete this configuration.
Parameter:
A.B.C.D/M:IPv4 address and mask length.
Command Mode:
Router Mode or Interface Configuration Mode.
Default:
Disabled.
Usage Guide:
If to configure aggregation route under router mode, RIP protocol must be enabled. If configured
under interface configuration mode, RIP protocol may not be enabled, but the aggregation router
can operation after the RIP protocol be enabled on interface.
Example:
To configure aggregation route as 192.168.20.0/22 globally.
Switch(config)#router rip
Switch(config-router) #ip rip agg 192.168.20.0/22
33.13 ip rip authentication key-chain
Command:
ip rip authentication key