PLANET XGS3-24042 - Manual (Page 756)

44-31
ip pim ignore-rp-set-priority
no ip pim ignore-rp-set-priority
Function:
When RP selection is carried out, this command configures the switch to enable Hashing regulation
and ignore RP priority. This command is used to interact with older Cisco IOS versions.
Default:
Disabled
Command Mode:
Global Mode
Usage Guide:
When selecting RP, Pim usually will select according to RP priority. When this command is
configured, pim will not select according to RP priority. Unless there are older routers in the net, this
command is not recommended.
Example:
Switch (config)#ip pim ignore-rp-set-priority
44.3.21 ip pim jp-timer
Command:
ip pim jp-timer <value>
no ip pim jp-timer
Function:
Configure to add JP timer. The “no ip pim jp-timer” command restores the default value.
Parameter:
<value> ranges from 10 to 65535s
Default:
60s
Command Mode:
Global Mode
Usage Guide:
Configure the interval of JOIN-PRUNE packets sent by PIM periodically, the default value is 60s.
The default value is recommended if no special reasons.
Example:
Configure the interval of timer
Switch (config)#ip pim jp-timer 59