PLANET XGS3-24042 - Manual (Page 699)

39-3
GRE Tunnel PACKET: recv, src <1.1.1.2>, dst <1.1.1.1>, size <140>, proto <0x0800>, from
39.2 ip address
Command:
ip address
no ip address
Function:
Configure the IPv4 address of GRE tunnel interface.
Parameter:
<ipv4-address> is IPv4 address, is the sub-net mask.
Command mode:
Tunnel interface configuration mode.
Usage Guide:
When configuring the interface address is IPv4 address for GRE tunnel, only one primary address
can be set, but secondary address can not be set. This limitation will also be used to other tunnels,
such as configure tunnel, 6to4, isatap.
Notice: the tunnel must stays in active state when configuring IPv4 address, so it is different to IPv6
address.
Example:
Configure the interface address is IPv4 address for GRE tunnel.
Switch(config)# interface tunnel 1
Switch(config-if-tunnel1)#ip address 11.0.0.1 255.255.255.0
39.3 ip route
Command:
ip route tunnel
no ip route tunnel
Function:
Configure the output interface of IPv4 static route as GRE tunnel.
Parameter:
<ipv4-address > is the IPv4 address, is the sub-net mask, is GRE tunnel ID.