PLANET XGS3-24042 - Manual (Page 437)

29-76
29.1.7 ipv6 dhcp relay subscriber-id option
Command:
ipv6 dhcp relay subscriber-id option
no ipv6 dhcp relay subscriber-id option
Function:
This command enables switch relay to support the option 38, the no form of this command disables
it.
Default:
Disable the relay option 38.
Command Mode:
Global configuration mode
Usage Guide:
Only after this command is configured, DHCPv6 relay agent can add option 38 in DHCPv6 request
packets before sending it to server or next relay agent. Make sure that DHCPv6 service has been
enabled before execute this command. The option 38 of switch relay is disabled by default.
Example:
Enable the switch relay to support option 38.
Switch(Config)#service dhcpv6
Switch(Config)#ipv6 dhcp relay subscriber-id option
29.1.8 ipv6 dhcp relay subscriber-id select delimiter
Command:
ipv6 dhcp relay subscriber-id select (sp | sv | pv | spv) delimiter WORD (delimiter WORD |)
no ipv6 dhcp relay subscriber-id select delimiter
Function:
Configures user configuration options to generate subscriber-id. The no form of this command
restores to its original default configuration, i.e. vlan name together with port name.
Parameters:
(sp | sv | pv | spv): a selection in combinations of slot, port and vlan, among which sp represents
slot and port, sv represents slot and vlan, pv represents port and vlan, and spv represents slot, port
and vlan.
WORD: the delimiter between slot, port and vlan which ranges among (#|.|,|;|:|/|space). Note that
there're two delimiter WORDs here, of which the former is the delimiter between slot and port and
the latter is the one between port and vlan.
Command Mode: