PLANET XGS3-24042 - Manual (Page 840)

44-115
44.10.18 ip igmp snooping vlan report source-address
Command:
ip igmp snooping vlan report source-address
no ip igmp snooping vlan report source-address
Function:
Configure forward report source-address for IGMP, the “no ip igmp snooping vlan
report source-address” command restores the default setting.
Parameter:
vlan-id: VLAN ID range<1-4094>;
A.B.C.D: IP address, can be 0.0.0.0.
Command Mode:
Global Mode.
Default:
Disabled.
Usage Guide:
Default configuration is recommended here. If IGMP snooping needs to be configured, the source
address for forwarded IGMP messages can be 0.0.0.0. If it is required by the upstream that IGMP
messages should use the same network address, the source address of IGMP messages should be
configured to be the same with upstream.
Example:
Switch (config)#ip igmp snooping vlan 2 report source-address 10.1.1.1
44.10.19 ip igmp snooping vlan specific-query-mrsp
Command:
ip igmp snooping vlan specific-query-mrsp
no ip igmp snooping vlan specific-query-mrspt
Function:
Configure the maximum query response time of the specific group or source, the no command
restores the default value.
Parameters:
: the specific VLAN ID, the range from 1 to 4094.
: the maximum query response time, unit is second, the range from 1 to 25, default value is
1.
Command Mode:
Global mode