PLANET XGS3-24042 - Manual (Page 537)

34-176
34.12 neighbor
Command:
neighbor <ipv6-address> {<ifname> vlan }
no neighbor <ipv6-address> {<ifname> vlan }
Function:
Specify the destination address for fixed sending. The “no neighbor <ipv6-address> <ifname>
vlan “cancels the specified address defined and restores all trusted gateways.
Parameter:
<ipv6-address> is the IPv6 Link-local address specified for sending and shown in colon hex
notation without the prefix length. <ifname> is the name of interface.
Default:
Not sending to any fixed destination address.
Command Mode:
Router mode
Usage Guide:
When used associating passive-interface command it would be able to send routing messages to
specified neighbor only.
Example:
Switch#config terminal
Switch(config)#router ipv6 rip
Switch(config-router)#neighbor FE80:506::2 Vlan1
Related Command:
passive-interface
34.13 offset-list
Command:
offset-list <access-list-number|access-list-name> {in|out} [|vlan
]
no offset-list <access-list-number|access-list-name> {in|out }[|vlan
]
Function:
Add an offset value on the routing metric value learnt by RIPng. The “no offset-list
<access-list-number|access-list-name> {in|out}[|vlan ]”