PLANET XGS3-24042 - Manual (Page 517)

33-156
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# maximum-prefix 150
33.26 neighbor
Command:
neighbor <A.B.C.D>
no neighbor <A.B.C.D>
Function:
Specify the destination address requires targeted-peer sending. The “no neighbor
<A.B.C.D>“command cancels the specified address and restores all gateways to trustable.
Parameter:
<A.B.C.D> is the specified destination address for the sending, shown in dotted decimal notation.
Default:
Not sending to any targeted-peer destination address.
Command Mode:
Router mode
Usage Guide:
When used accompany with passive-interface command it can be configured to only sending
routing messages to specific neighbor.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# neighbor 1.1.1.1
Related Command:
passive-interface
33.27 network
Command:
network |ifname>
no network |ifname>
Function:
Configure the RIP protocol network.