PLANET XGS3-24042 - Manual (Page 969)

48-5
48.7 dot1x enable
Command:
dot1x enable
no dot1x enable
Function:
Enables the 802.1x function in the switch and ports: the "no dot1x enable" command disables the
802.1x function.
Command mode:
Global Mode and Port Mode.
Default:
802.1x function is not enabled in global mode by default; if 802.1x is enabled under Global Mode,
802.1x will not be enabled for the ports by default.
Usage Guide:
The 802.1x authentication for the switch must be enabled first to enable 802.1x authentication for
the respective ports. If Spanning Tree or MAC binding is enabled on the port, or the port is a Trunk
port or member of port aggregation group, 802.1x function cannot be enabled for that port unless
such conditions are removed.
Example:
Enabling the 802.1x function of the switch and enable 802.1x for port1/0/12.
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/0/12
Switch(Config-If-Ethernet1/0/12)#dot1x enable
48.8 dot1x guest-vlan
Command:
dot1x guest-vlan <vlanid>
no dot1x guest-vlan
Function:
Set the guest-vlan of the specified port; the “no dot1x guest-vlan” command is used to delete the
guest-vlan.
Parameters:
the specified VLAN id, ranging from 1 to 4094.
Command Mode:
Port Mode.