PLANET XGS3-24042 - Manual (Page 491)

31-130
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set tag 60
31.28 set vpnv4 next-hop
Command:
set vpnv4 next-hop <ip_addr>
no set vpnv4 next-hop [>]
Function:
Configure the next-hop of BGP VPNv4 routing message. The “no set vpnv4 next-hop
[>]” command deletes the configuration.
Parameter:
> is the next-hop ip address of VPNv4 route shown by dotted decimal notation.
Command Mode:
route-map mode
Usage Guide:
To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set vpnv4 next-hop 10.1.1.1
31.29 set weight
Command:
set weight >
no set weight [>]
Function:
Configure the weight value of BGP routing message. The “no set weight [>]”
command deletes this configuration.
Parameter:
> is weight value, ranging between 0～4294967295
Command Mode:
route-map mode
Usage Guide: