PLANET XGS3-24042 - Manual (Page 115)

XGS3 Command Guide
3-115
3.7 cluster member
Command:
cluster member {nodes-sn | mac-address [id ]}
no cluster member {id | mac-address }
Function:
On a commander switch, manually add candidate switches into the cluster created by it.
Parameters:
nodes-sn：all cluster member switches as recorded in a chain list, each with a node sn which can be viewed by “show
cluster candidates” command. One or more candidates can be added as member at one time. The valid range of
candidate-sn-list is 1~256.
mac-address：the CPU Mac of candidate switches
member-id：A member id can be specified to a candidate as it becomes a member, ranging from 1 to 128, increasing
from 1 by default.
nodes-sn is the automatically generated sn, which may change after the candidate becomes a member. Members
added this way will be actually treated as those added in mac-addr mode with all config files in mac-addr mode.
If more than one switch is added as member simultaneously, no member-id is allowed; neither when using nodes-sn
mode.
Command Mode:
Global Mode
Usage Guide:
After executing this command, the switch will add those identified in or into the cluster
it belongs to. One or more candidates are allowed at one time, linked with ‘-‘ or ‘;’. A switch can only be member or
commander of one cluster, exclusively. Attempts to execute the command on a non commander switch will return
error. The no operation of this command will delete the specified member switch, and turn it back to a candidate.
Example:
In the commander switch, add the candidate switch which has the sequence number as 1. In the commander switch,
add the switch whose the mac address is 11-22-33-44-55-66 to member, and the member-id is 5.
Switch(config)#cluster member nodes-sn 1
Switch(config)#cluster member mac-address 11-22-33-44-55-66 id 5
3.8 cluster member auto-to-user
Command:
cluster member auto-to-user
Function:
All members will be deleted when configuring no cluster auto-add. Users need to change automatically added