PLANET XGS3-24042 - Manual (Page 1134)

69-8
69.15 ntp multicast client
Command:
ntp multicast client
no ntp multicast client
Function:
Configure the specified interface to receive NTP multicast packets, the no command will cancels the
specified interface to receive NTP multicast packets.
Command mode:
Interface mode
Default:
Interface does not receive NTP multicast packets.
Example:
Enable the function for receiving NTP multicast packets on vlan1 interface.
Switch(Config)# interface vlan 1
Switch(Config-if-Vlan1)#ntp multicast client
69.16 ntp server
Command:
ntp server {<ip-address> | } [version >] [key <key-id>]
no ntp server {<ip-address>|}
Function:
To enable specified time server of time source, the no form of this command cancels the specified
time server of time source.
Parameter:
ip-address: IPv4 address of time server.
ipv6-address: IPv6 address of time server.
version: The version information configured for server.
version_no: The version number of server, range is from 1 to 4, default is 4.
key: To configure key for server.
key-id: The key id.
Default:
Disabled.
Command Mode:
Global Mode.