PLANET XGS3-24042 - Manual (Page 356)

19-202
Command:
arp > {interface [ethernet] <portName>}
no arp
Function:
Configures a static ARP entry; the “no arp ” command deletes a ARP entry of the
specified IP address.
Parameters:
is the IP address, at the same field with interface address; is the
MAC address; ethernet stands for Ethernet port; for the name of layer2 port.
Default:
No static ARP entry is set by default.
Command mode:
VLAN Interface Mode
Usage Guide:
Static ARP entries can be configured in the switch.
Example:
Configuring static ARP for interface VLAN1.
Switch(Config-if-Vlan1)#arp 1.1.1.1 00-03-0f-f0-12-34 interface eth 1/0/2
19.5.2 clear arp-cache
Command:
clear arp-cache
Function:
Clears ARP table.
Command mode:
Admin Mode
Example:
Switch#clear arp-cache
19.5.3 clear arp traffic
Command:
clear arp traffic
Function:
Clear the statistic information of ARP messages of the switch. For box switches, this command will