PLANET XGS3-24042 - Manual (Page 878)

45-23
<access-list name> is the applying simple access-list.
Command Mode:
Global Mode
Usage Guide:
This command is used to interact with older Cisco IOS version.
Example:
Configure the register packet’s checksum of the group specified by myfilter to use the whole
packet’s length.
Switch(config)#ipv6 pim cisco-register-checksum group-list myfilter
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit ff1e::10/128
45.3.16 ipv6 pim dr-priority
Command:
ipv6 pim dr-priority
no ipv6 pim dr-priority
Function:
Configure, disable or change the interface’s DR priority. The neighboring nodes in the same net
segment select the DR in their net segment according to hello packets. The “no ipv6 pim
dr-priority” command restores the default value.
Parameter:
priority, it ranges from 0 to 4294967294
Default:
1
Command Mode:
Interface Configuration Mode
Usage Guide:
Range from 0 to 4294967294, the higher value has more priority. The command can configure on
IPv6 tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example:
Switch (config)# interface vlan 1
Switch(Config-if-Vlan1)ipv6 pim dr-priority 100
45.3.17 ipv6 pim exclude-genid