PLANET XGS3-24042 - Manual (Page 1208)

76-26
Related Commands:
request-retry
76.41 router ldp
Command:
router ldp
no router ldp
Function:
Enable the LDP protocol; the no operation will disable it.
Default:
LDP is disabled.
Command Mode:
Global Mode.
Usage Guide:
The LDP protocol is a label advertising protocol used when switching labels in the public network,
which usually works in a BGP VPN environment. Implementing this command will globally enable
the LDP protocol, however, in interfaces where the protocol is actually working, implementing
“enable-ldp” in the interface configuration mode is required, so does enabling Label-switching,
which, in combination with this command, work as a whole to ensure the normal operation of the
protocol.
Example:
Switch(config)#router ldp
Switch(config-router)#
76.42 router-id
Command:
router-id <ip-addr>
no router-id
Function:
Set the router ID used by LDP; the no operation will cancel the configuration.
Parameters:
is the router ID, in dotted decimal format.
Default: