PLANET XGS3-24042 - Manual (Page 410)

27-49
Default:
Any DHCPv6 address pool are not configured by default.
Command Mode:
Global Mode.
Usage Guide:
This command should be launched in global configuration mode, and falls in DHCPv6 address pool
configuration mode if launched successfully. To remove a configured address pool, interface
bindings related to the address pool, as well as the related address bindings will be removed.
Example:
To define an address pool, named 1.
Switch(config)#ipv6 dhcp pool 1
27.15 ipv6 dhcp relay destination
Command:
ipv6 dhcp relay destination {[] [interface { | vlan
<1-4096> } ] }
no ipv6 dhcp relay destination { [] [ interface { | vlan
<1-4096> } ] }
Function:
To configure the destination to which the DHCPv6 relay forwards the DHCPv6 requests from the
clients, the destination should be the address of an external DHCPv6 relay or the DHCPv6 server.
The no form of this command will remove the configuration.
Parameters:
is the address of the destination to which the DHCPv6 relay forwards;
> or VLAN is the interface name or VLAN id which is used for forwarding of
DHCPv6 requests, > should be a lay three VLAN name, and the VLAN id is limited
between 1 and 4096. If <ipv6-addess> is a global unicast address, the interface parameter should
not be configured; If <ipv6-address> is an local address, the interface parameter is required be
configured; The destination address for the DHCPv6 server will be the multicast address of
ALL_DHCP_Servers (FF05::1:3), if the interface parameter is configured only.
Command Mode:
Interface Configuration Mode.
Default:
By default, destination address for DHCPv6 relay is not configured.
Usage Guide:
This command is used to configure the DHCPv6 relay for the specified interface, the address