PLANET XGS3-24042 - Manual (Page 1173)

74-3
74.4 debug driver
Command:
debug driver {receive | send} [interface { | all}] [protocol { |
discard | all}] [detail]
no debug driver {receive | send}
Function:
Turn on the on-off of showing the information of the CPU receiving or sending packets, the “no
debug driver {receive | send}” command turns off the on-off.
Parameter:
receive | send show the information of receiving or sending packets;
interface {| all}: interface-list is the Ethernet port number, all indicate all the
Ethernet ports.
protocol { | discard | all}: protocol-type is the type of the protocol of the packet,
including snmp, telnet, http, dhcp, igmp, hsrp, arp, bgp, rip, ospf, pim, ssh, vrrp, ripng, ospfv3, pimv6,
icmpv6, bgp4plus, unknown-mcast, unknown-mcast6, ttl0-2cpu, isis, dot1x, gvrp, stp, lacp, cluster,
mld, vrrpv3, ra, uldp, lldp, eapou all means all of the protocol types, discard means all the
discarded packets. Detail show detail information.
Command Mode:
Admin Mode
Usage Guide:
This command is used to debug, it is supposed to be used with the help of the technical support.
Example:
Turn on the on-off for showing the receiving packets.
Switch#debug driver receive
74.5 show cpu-rx protocol
Command:
show cpu-rx protocol [ ]
Function:
Show the statistics of the CPU received packets of the specified protocol type.
Parameter:
<protocol- type> is the protocol type of the packets, if do not input parameters, show all statistic
packets.
Command Mode: