PLANET XGS3-24042 - Manual (Page 450)

30-89
Chapter 30 Commands for DHCP
Snooping
30.1 debug ip dhcp snooping binding
Command:
debug ip dhcp snooping binding
no debug ip dhcp snooping binding
Function:
This command is use to enable the DHCP SNOOPING debug switch to debug the state of binding
data of DHCP SNOOPING.
Command Mode:
Admin mode
Usage Guide:
This command is mainly used to debug the state of DHCP SNOOPING task when it adds ARP list
entries, dot1x users and trusted user list entries according to binding data.
30.2 debug ip dhcp snooping event
Command:
debug ip dhcp snooping event
no debug ip dhcp snooping event
Function:
This command is use to enable the DHCP SNOOPING debug switch to debug the state of DHCP
SNOOPING task.
Command Mode:
Admin mode.
Usage Guide:
This command is mainly used to debug the state of DHCP SNOOPING task and available of
outputting the state of checking binding data and executing port action and so on.