Network settings – TA Triumph-Adler P-C4580DN User Manual
Page 28
Preparation before Use
2-4
Network Settings
This section explains the settings for when DHCP is used or when an IP Address is entered while TCP(IPv4) is selected.
For details of the settings, refer to Network (Network settings) on page 6-40. Also, for how to use the Menu Selection
System, refer to Using the Menu Selection System on page 2-43.
1
While the printer displays Ready to print., Please wait.,
Sleeping.
and Processing., press [Menu]. The Mode Selection
Menu is displayed.
2
Press
or to select Network.
3
Press [OK]. The Network menu screen appears.
Security
Network Security
WSD-PRINT
On/Off
Enhanced WSD
On/Off
EnhancedWSD(SSL)
On/Off
IPP
On/Off
SSL Setting
SSL
Off/On
On/Off
Encryption
AES/DES/3DES
IPP over SSL
On/Off
HTTPS
On/Off
IPSec
On/Off
Thin Print
Off/On
On/Off
Thin Print over SSL
On/Off
LAN Interface
Auto/10BASE-Half/
10BASE-Full/
100BASE-Half/
100BASE-Full/
1000BASE-T
Note After all network related settings have been done, turn the machine OFF and ON again. This is mandatory to
make the settings effective!
Note When entering an IP Address manually, check the IP Address, Subnet Mask and Default Gateway with the
system administrator.
Menu
Submenu
Setting
Menu:
a
b
********************-
2 USB Memory
3 Counter
[ Exit
]
1 Report Print
Network:
a
b
********************-
2 Restart Network
[ Exit
]
1 TCP/IP Settings