TA Triumph-Adler P-C4580DN - Manual (Page 168)

Operation Panel
6-44
IPv6 Setting (TCP/IP IPv6 settings)
Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6): Off".
IMPORTANT After changing the setting, restart the network, or turn the machine OFF and then ON. For detailed
information on restarting the network, refer to Restart Network (Restarting the network card) on page 6-47.
The options available in the TCP/IP (IPv6) settings are as follows:
• TCP/IP (IPv6) (Enable/disable TCP/IP (IPv6))...6-44
• RA (Stateless) (RA (Stateless) setting)...6-45
• DHCPv6 (DHCPv6 setting)...6-45
IMPORTANT The RA (Stateless) and DHCPv6 menu options for TCP/IP (IPv6) are displayed when TCP/IP (IPv6) is
enabled.
1
In the TCP/IP Settings menu, press  or  to select IPv6
Setting .
2
Press [OK]. The IPv6 Setting menu screen appears.
TCP/IP (IPv6) (Enable/disable TCP/IP (IPv6))
This specified whether TCP/IP (IPv6) is used.
1
In the IPv6 Setting menu, press
 or  to select TCP/IP(IPv6).
2
Press [OK]. The TCP/IP(IPv6) screen appears.
3
Press  or  to select whether TCP/IP (IPv6) is enabled.
4
Press [OK]. The TCP/IP (IPv6) setting is set and the IPv6 Setting
menu reappears.
IPv6 Setting:
a b
********************-
[ Exit ]
1 TCP/IP(IPv6)
TCP/IP(IPv6):
a b
********************-
2 On 1
*Off