Yaskawa iQpump Micro - Manual (Page 100)

Figure 4.12 Home Quick Monitor Screen
The following monitors are available via the Quick Monitor:
Monitor Name
U1-01 Frequency Reference
U5-99 Auto Setpoint
U1-02 Output Frequency
U1-03 Output Current
U1-06 Output Voltage
U1-07 DC Bus Voltage
U1-08 Output Power
U1-10 Input Terminal Status
Monitor Name
U1-11 Output Terminal Status
U1-13 Terminal A1 Level
U1-14 Terminal A2 Level
U1-25 CPU 1 SW Number
U4-01 Drive Elapsed Time
U9-02 iQ Network Activity
U1-99 Anti-No-Flow Timer
u Changing Parameter Settings or Values
This example explains changing C1-02 (Deceleration Time 1) from 10.0 seconds (default) to 20.0 seconds.
Note: During serial communication writing, if a parameter change is also attempted via the HOA keypad, a “BUSY - WRITE PROTECTED”
message will display. Parameter change will not be possible from the HOA keypad until an Enter command is received via the serial
communication to finish the serial writing process.
Step Display/Result
1. Turn on the power to the drive. The initial display appears.
- MODE -
U5-99= 0.0PSI
U1-02= 0.00Hz
U1-91= 0.0PSI
DRV
Auto Setpoint
Rdy
<-MONITOR->
LSEQ
LREF
2. Press
or until the Parameter Setting Mode screen appears.
Home
- MODE - PRG
Programming
FWD
3. Press
to enter the parameter menu tree.
-PRMSET-
Initialization
Select Language
PRG
FWD
A 1-00= 0
Home DATA
4. Press
or to select the C parameter group.
-PRMSET-
Basic Setup
Accel Time 1
PRG
FWD
C 1-01= 20.0 sec
FWD Home DATA
5. Press
two times.
-PRMSET-
Accel/Decel
Accel Time 1
PRG
FWD
C 1 -01= 20.0sec
-PRMSET-
C1- 01 = 20.0sec
(0.0~6000.0)
“20.0 sec”
PRG
Accel Time 1
FWD Home Home DATA DATA
4.5 Using the Optional HOA Keypad
100 YASKAWA TOEP YAIQPM 03B YASKAWA AC Drive - iQpump Micro User Manual