SMA Sunny Data Control V.4.2 - Manual (Page 82)

Displaying Data SMA Technologie AG
Page 82 SDC-TEN080642 User Manual
Configuring the Total Overview Display
1. Select the values which are to be displayed. To do so, click on the check box
alongside the desired value (e.g. "Show total power", "Show daily yield") and
add or remove the check mark.
2. Configure the display of the total overview as desired. The following settings can
be adjusted:
• Text:Here, you can type in a text for the display (e.g. "Pac" for the total output,
and "E-total" for the total yield).
• Unit:Here, you can choose between the units W, kW and MW in the drop-down
list.
• Here, you can set the number of decimal places with which the values are to be
displayed (# = no decimal places... #.### = three decimal places).
• Factor:Here, you can enter a factor by which the calculated value is to be
multiplied.
• Here, you can enter a corrective value which is to be added to the calculated
value.
3. When finished, click on to save the settings.
Example