SMA Sunny Data Control V.4.2 - Manual (Page 111)

SMA Technologie AG Managing Data and Saving Data Locally
User Manual SDC-TEN080642 Page 111
11.6. 1 Storage Time Refresh
Sunny Data Control displays the time ranges of newly recorded values from the
communication device which have not yet been read out (see figure below).
In Sunny Data Control, the time ranges update only when the program is started up. If
you have kept Sunny Data Control open for a longer period of time, and wish to read
out newly recorded data, you must first update the time ranges.
1. Select "Options / Storage Time Refresh". The time ranges update.
2. Read out the data.
You can also set the time ranges which you wish to read out, as described in the next
section, 11.6. 2 „Setting Time Ranges” (page 112).
Start and end of the recording of new values in the Sunny Boy Control
since the last time Sunny Data Control was started up.
Example (excerpt from the "Archiv channels" list)
This time range is read out.