SMA Sunny Data Control V.4.2 - Manual (Page 67)

SMA Technologie AG Displaying Data
User Manual SDC-TEN080642 Page 67
1. In the device overview, use the right mouse button to click on the field of the device
for which you wish to set the channels for spot value queries. The device overview
menu opens.
2. Select "Channel Selection“. The window for setting the selected device's channels
opens (see figure below).
You can also call up the window in the following way: select the device for which
you wish to set the channels by clicking on the device's field with the left mouse
button in the device overview. Select the menu item "Spotvalues / Channel Selec-
tion“.
3. Under "Channel selection is valid for" (see figure above), select whether you wish
to set the channel selection for the selected device only, or for all devices of a par-
ticular type.
4. Use the arrow buttons to add or remove the desired channels for the respective
spot value queries.
Select whether the channel selection shall only apply to this device
Selected device
(clicked on previously)
(clicked on previously), or for a particular device type.