Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 77)

Kalypso Machine Control Interfaces Installation Instructions 77
Kalypso Installation and Configuration
Map Each Source to a Kalypso Panel Button
1. Go to the Button Mapping menu by touching the Daily Setups button on
the Menu panel, then press User Prefs and Button Mapping buttons.
2. Assign each VTR source from the right scrolling pane to the desired
menu button on the left scrolling pane (
Figure 62 ).
Figure 62. Button Mapping Menu, with Profile Sources Assigned
Save Kalypso Configuration Files
You should now save the Kalypso Engineering Setup file and User Prefs
files that contain the new machine control settings. This is accomplished
from the Save Load menu for Eng Setup, and the separate Save Load menu
for Daily Setups. Refer to the separate Kalypso User Manual for specific
instructions.
Note If after testing the interface, changes must be made to the Kalypso settings,
remember to save the modified Eng Setup and User Prefs configuration files.