Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 56)

56 Kalypso Machine Control Interfaces Installation Instructions
Section 2 — Profile Interface
20. Click on MAIN MENU , then click on the Control item on the right. A menu
will appear for the Profile channel that was last selected ( Figure 48 ).
Figure 48. VDRCS Control Menu
21. Click LOAD and choose a clip from the list of recorded clips.
22. Select that Profile source on a PVW bus on the Kalypso switcher so its
image can be seen on a monitor.
Note Do not use the PGM bus, because when the device is on-air it cannot be con-
trolled from another location.
23. On the VDRCS menu (not the Kalypso Main panel), click on the play
and stop buttons to roll and stop the clip and view the monitor to
confirm that control at this level exists.
24. Exit VDRCS by clicking on the MAIN MENU item on the right task bar,
then clicking on the Disconnect message box.