Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 48)

48 Kalypso Machine Control Interfaces Installation Instructions
Section 2 — Profile Interface
Map Each Source to a Kalypso Panel Button
1. Go to the Button Mapping menu by touching the Daily Setups button on
the Menu panel, then press User Prefs and Button Mapping buttons.
2. Assign each Profile VDR source from the right scrolling pane to the
desired menu button on the left scrolling pane (
Figure 40 ).
Figure 40. Button Mapping Menu with Profile Sources Assigned
Save Kalypso Configuration Files
You should now save the Kalypso Engineering Setup file and User Prefs
files that contain the new machine control settings. This is accomplished
from the Save Load menu for Eng Setup, and the separate Save Load menu
for Daily Setups. Refer to the separate Kalypso User Manual for specific
instructions.
Note If after testing the interface, changes must be made to the Kalypso settings,
remember to save the modified Eng Setup and User Prefs configuration files.