Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 38)

38 Kalypso Machine Control Interfaces Installation Instructions
Section 2 — Profile Interface
15. Keep the Yes restart computer option selected and click OK . A finish
screen appears briefly and then the computer restarts ( Figure 32 ).
Figure 32.
16. If you chose No above, click Finish .
17. Remove the VDRCS CD from the Profile’s CD-ROM drive and store it
in a safe place.
18. Reboot the Profile to complete the installation.
You now must continue with the installation and configuration procedures
for the Kalypso and Encore systems.
Install VDRCS over Network
If the Profile does not have a CD-ROM drive, software can be installed over
the network.
A standard PC with a CD-ROM can be connected to the network for this
purpose, or
1. If necessary, set up the Profile to communicate over the network, using
the Windows controls at Start\Settings\ControlPanel\Network.
2. The Kalypso system CD-ROM can be used, which should already be
configured on the network. Alternatively, you can use any PC with a
CD-ROM drive, but it will need to be configured and connected to the
network. In either case, the devices must be in the same Windows
Workgroup.
3. Insert the KAL-IF-PROFILE CD into the CD-ROM drive of the Kalypso
system or PC connected to the network. You will need to know the
name of the computer and the path to reach it over the network.