Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 32)

32 Kalypso Machine Control Interfaces Installation Instructions
Section 2 — Profile Interface
Install VDRCS from CD
If the Profile has a CD-ROM drive, install the software using that drive.
1. Exit any open applications.
2. Insert the KAL-IF-PROFILE CD into the CD-ROM drive of the Profile. The
installer program will launch automatically and a caution message is
posted reminding you to uninstall any previous instance of VDRCS, if
present (
Figure 20 ). This is required to prevent installation problems.
Figure 20.
3. Click on Proceed (or Cancel and do the uninstall, described on page 31 ).
A Profile model selection screen is displayed ( Figure 21 ).
Figure 21.
4. Select the Profile model you are installing onto and click Install . This is
important because it chooses the software version required for that
Profile model.
Note Later in the procedure you will be asked again for the Profile model, but that
later choice does NOT select different software. It only identifies the target of
the install. You must select the correct Profile model both times.