Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 22)

22 Kalypso Machine Control Interfaces Installation Instructions
Section 1 — Machine Control Overview
10. Click on the Start button and log on to the Encore GUI as user KAL to
test that the new user was added. The name KAL replaces Start on the
lower right button ( Figure 18 ).
Figure 18.
Note The KAL logon has permissions for operational control only. To change con-
figuration settings you must log on as SYS.
11. If you are doing an initial Machine Control Support Software
installation, go back to
Confirm Machine Control Support Installation on
page 16 .