Grass Valley Machine Control Interfaces V.12.0 User Manual
Page 13
Kalypso Machine Control Interfaces Installation Instructions
13
Machine Control Support Software Installation
4.
Select the appropriate installation options, as described in the
following bulleted paragraphs.
CAUTION Only one Sharer and System Manager is to be installed on a network.
•
If you are installing machine control on your Kalypso system for
the first time and do not have an OmniBus facility management
system on the network, select
Encore User Interface
and
Sharer/System
Manager
and
Default Configuration Data Base
. Additional OmniBus or
Encore system configuration steps will also be required.
•
If you are updating a Kalypso system already running a machine
control option and do not have an OmniBus facility management
system elsewhere on the network, select
Encore User Interface
and
Sharer/System Manager
. The existing configuration will be retained.
CAUTION If updating existing Machine Control software on a Kalypso system, do NOT
choose the Default Configuration Database option, as it will overwrite the
existing configuration information.
•
If you are updating a Kalypso system already running a machine
control option and have an Omnibus facility management system
running elsewhere on the network, select
Encore User Interface
and
Base Install Only
. The existing configuration will be retained.
CAUTION If an existing OmniBus facility management system or an Encore control
system exists on the network, do NOT choose the Default Configuration Data-
base option. If it is installed to the same location as the existing database, the
existing configuration information will be overwritten, disabling the OmniBus
or Encore system.
5.
After making your selections, touch
Install
. During the subsequent
installation process several prompt and selection screens appear in
sequence. Different screens are displayed (
options originally chosen above. Carefully follow the on-screen
directions, and always use the default selection when choices are
offered.