Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 118)

118 Kalypso Machine Control Interfaces Installation Instructions
Section 4 — Using the Encore Operational User Interface (OUI)
Clicking the Fast Forward button fast-forwards the clip that is loaded in the
currently selected device; the button shows white. Once fast-forwarding is
complete, the
Fast Forward button shows grey and the Pause button is auto-
matically selected and shows white.
Clicking the Stop button stops the currently selected device; the button
shows white.
The Shuttle Bar provides incremental control of the currently selected
device.
Cue Points Area
The Cue Points Area enables you to recall a clip at relevant points within
the clip. The functions of the different buttons are described below.
Using the Cueing Control Buttons
1. Load a clip.
2. Play the clip.
3. Click the Set button so it becomes green.
4. Click one of the Cueing Control ( M1 to M6 ) buttons to store the time code
of a point in the clip. The Set indicator button becomes grey.
(You can pause the clip at the point before storing the time code if you
want to.)
5. Click the Set button (so it becomes green) and then a Cueing Control
button for each time code you want to store.
6. While the Set button is grey, clicking a Cueing Control button pauses the
clip at the stored time code.
7. Click the GoTo button and enter a time code in the Keypad displayed.
The clip pauses at that time code.
8. Click the In button or the Out button to pause the clip at the marked-in
or marked-out point.
Note The Cueing Control buttons store the time codes you allocate to them. The
time codes are not stored with the clip, and are only retained during the LMCP
session in which you define them. They are lost if you overwrite them or if
you switch the OUI workstation off. If you load a new clip, the stored time
codes apply to this also.