Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 27)

Kalypso Machine Control Interfaces Installation Instructions 27
Uninstall Old Omnibus User Interface
Uninstall Old Omnibus User Interface
If the Kalypso system has previously been running an earlier version of
machine control, you can remove the older OmniBus User Interface if you
wish. While leaving the older OUI installed will not cause problems when
running the Encore User Interface, removing it prevents accidentally
loading the older version, which could cause confusion.
1. Go to Start\Settings\Control Panel\Add/Remove programs and
uninstall
OUI .
2. If running Windows NT, delete the wincui icon from the desktop.
Windows 2000 should remove the icon automatically.
Reverting to Earlier Machine Control Software
If you wish to revert to an earlier version of machine control software, you
must uninstall the newer machine control version before installing the
older version.
1. Exit any open applications. You will need to exit Watchdog before you
can exit the Sharer.
2. Go to Start\Settings\Control Panel\Add/Remove Programs.
3. Uninstall the following items:
• Kalypso Machine Control
• OmniBus Sharer , or Base Install (which of these items is present
depends on the installation options selected)
• OUI
Note The machine control database cannot be removed with Add Remove. This is
intentional to prevent accidental loss of configuration data. If a new default
data base is installed, it will overwrite the existing flies located in C:\Omn.
4. Now install the older machine control software (OmniBus) using the
older Kalypso Software CD.