Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 39)

Kalypso Machine Control Interfaces Installation Instructions 39
Profile Installation and Configuration
4. Share the disk in the CD drive of the PC:
a. Double click on My Computer and select the CD drive (generally D: or
E:)
b. Select File , Sharing .
c. Click on Shared As .
d. Enter a share name, for example KAL_CD.
e. Click on Permissions and select Everyone , Full Control .
f. Click OK , and click OK again.
5. On the Profile, use Network Neighborhood to navigate to the PC with
the shared drive.The default name for the Kalypso Menu panel is
Kalypsomenu1. If prompted for a name and password, enter the name
KALYPSO and the password kalypso (must be lower case).
6. Open the drive and run the Install from CD procedure as described on
page 32 .
7. If you have multiple Profiles on the network, go to each one in turn and
repeat
Step 5 .
8. Remove the CD from the PC and store it in a safe place.
Edit Batch File for Fibre Channel or PLS 200
During installation a batch file is installed on the Profile for setting Fibre
Channel and PLS200 operation. The defaults are Fibre Channel ON and
PLS200 OFF. If you are not using Fibre Channel, or have a PLS 200
installed, the
c:\omnibus\app_omn\AppStart.bat batch file will need to be edited.
1. Make the batch file editable:
a. Right click on AppStart.bat and select Properties .
b. Uncheck the Read only attribute and click OK .
2. Open the file in Notepad for editing by right clicking on AppStart.bat and
selecting Edit .
3. If you will not be using Profile Fibre Channel clip transfers, add REMs
to the following section:
REM echo Starting App_Fibre . . .
REM start "OmniBus Fibre" /D\Omni-
Bus\App_Omn\!App_Fibre\ /MIN \Omni-
Bus\App_Omn\!App_fibre\App_Fibre.exe
4. If the Profile is connected to a PLS200 remove the REMs from the
following section: