Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 69)

Kalypso Machine Control Interfaces Installation Instructions 69
Kalypso Installation and Configuration
Kalypso Installation and Configuration
Install Encore Software
If you have not already done so, install the
appropriate Encore software using the
Kalypso Software CD (see
Machine Control
Support Software Installation on page 11 ).
Note If you have Omnibus already running at
your facility, then do not install it on the
Kalypso system. Similarly, if you have
more than one Kalypso system on the
network, then the Sharer and System
Manager should be loaded on only one of
these systems.
You now need to configure the Kalypso
system to recognize the VTR for machine
control.
Kalypso Installation and Configuration
(page 69)
Map Each Source
to a Kalypso
Panel Button
(page 77)
Create a New VTR
Device Definition
(page 70)
Assign VTR
Devices to
Kalypso Sources
(page 74)
Install Machine
Control Support
Software
(page 12)