Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 119)

Kalypso Machine Control Interfaces Installation Instructions 119
Local Machine Control Panel (LMCP)
Ancillary Area
The buttons in the Ancillary Area are used to access specific functions of
the LMCP application.
Options button
1. Click the Options button to display the Options window.
2. Click the first button bar to select the option for creating daughter and
clone clips.
3. Switch on the Load virtual clip indicator if you want to activate this
option.
4. Click the Size button to set the default duration of a new clip.
5. Select either the Filer Loading or List Loading option by clicking the
respective indicator buttons; an indicator shows green to highlight
your choice. (See
Filer-Fax on page 121 ).
6. Switch on the Modify Clip Options button (so its indicator shows green), if
you want the system to update the current clip options when you
change the clip type. If you do not switch it on, the system leaves the
clip options unchanged.
7. Click the Mode button to select the routing option required; the selected
option is displayed in the button bar.
8. If you select Auto Mode, click the Dest button to display the Router
Destinations list window and select one of the available router
destinations. The one you select is shown next to the
Dest button. If you
select Manual Mode, the Dest button is unavailable.
9. Select Use object database if you want the LMCP to use the object
database — you need special system privileges to change this setting.
Figure 91. Options window