Grass Valley K2 Dyno v.2.0 - Manual (Page 93)

14 June 2011 K2 Dyno Controller Operator Manual 93
Configuring the T-Bar settings: default and alternate
Any changes you make to the M/E settings in the Config screen during a session are
not reflected to the M/Es that are already being used in a playlist. If you load a playlist
that has effects which are no longer reflected in the configuration, that playlist event
displays “ME” rather than a specific effect such as ME1 or ME2.
Configuring the T-Bar settings: default and alternate
1. Touch Config | Panel , and then touch T-BAR .
2. If configuring the Default settings, refer to the following table.
No. Name Function
(1) Default setting Select to apply remaining settings to normal T-Bar operation.
(2) Clip type Set the clip type as follows:
x1: Normal clip
x2: Super Slo-Mo x2 clip
x3: Super Slo-Mo x3 clip
When you select a clip type, the remaining settings apply to that clip
type.
(3) Configure position Enter your desired T-Bar position as a numeric value.
(4) Speed Set the playing speed corresponding to the T-Bar position.
(1)
(2)
(3)
(4)