Grass Valley K2 Dyno v.2.0 - Manual (Page 39)

14 June 2011 K2 Dyno Controller Operator Manual 39
About play speed
The controller will go back to the In point of the scene, and replay the scene with
a different angle.
• The playback speed remains the same even if you switch the camera during a
slo-mo playback.
• If the playback is stopped such as moving the T-Bar back to the 0% position after
replaying a scene in step 1, the controller cues up to the In point of the scene after
the operation in step 3.
• If you perform the steps 2 to 3 again when playing the record train, the controller
will go back to the playback point prior to switching the camera angles instead of
going back to the scene's In point.
About play speed
When you press the Play button, play speed behaves as follows:
T-bar behavior
When you use the T-bar, play speed behaves as follows:
Flying M/E behavior
Flying M/E between Super Slo-Mo clips and normal clips behaves as follows:
Internal speed Displayed speed
Normal clip 100% 100%
Super Slo-Mo x2 clip 100% 50%
Super Slo-Mo x3 clip 100% 33%
Lever position Internal speed Displayed speed
Normal clip Maximum 100% 100%
Minimum 0% 0%
Super Slo-Mo x2 clip Maximum 200% 100%
Minimum 0% 0%
Super Slo-Mo x3 clip Maximum 300% 100%
Minimum 0% 0%
Play Mode
Keep internal speed
Super Slo-Mo x3 clip
<
==================
>
Super Slo-Mo x3 clip
Internal speed 100%
Display speed 33%
Internal speed 100%
Display speed 100%
Variable Mode
Keep display speed