Grass Valley K2 Dyno v.2.0 - Manual (Page 38)

38 K2 Dyno Controller Operator Manual 14 June 2011
Chapter 3 Playback
Replay
A replay lets you go back and play a scene that you found during a live playback
again. You can use the following methods: to search and replay a scene with the Jog
knob or to mark a scene in advance for cueing up and replaying it as necessary.
This section describes how to go back and replay a scene using the Jog knob. For
information on how to replay a scene by marking and cueing up, see
"Marking and
cueing up" on page 47 .
1. Begin a live playback.
2. When an important scene is found, rotate the Jog knob to the left
(counter-clockwise) to go back to the beginning of the scene.
3. Play the scene with the T-Bar.
• Fully pushing up the T-Bar plays the scene with the 100% speed. If you want to
play it at a slower speed, move and fix the T-Bar in a desired position.
• If Super Slo-Mo, positioning the T-Bar in the middle plays at the Super Slo-Mo
speed. For example, if Super Slo-Mo x3, the middle position speed is 33%.
• The speed is indicated on the screen.
• Pressing the Play button plays the scene with the 100% speed.
• If you operate the Jog knob or T-Bar, mark-in and mark-out points are added to
the record train and are displayed in the Mark screen.
Switching cameras
This section describes how to switch cameras during a live playback and replay.
You can apply effects (Flying M/E), such as dissolves, to the video when replaying a
scene or switching cameras during a playlist or highlight playback. To enable Flying
M/E, press the
Shift button and then press the M/E button. If a keyboard is connected,
you can enable/disable Flying/ME by pressing the [F1] key. For more information on
how to set the Flying M/E setting, see
"Mix effect settings" on page 92 .
Switching camera angles
1. Begin a live playback.
Press the A / B / C button or press the D / E / F button after pressing the Shift button.
The button for the selected camera lights up in red.
NOTE: The playback speed remains the same even if you switch the camera during
a slo-mo playback.
Replaying the same scene with another angle
You can go back and replay a scene from the scene's In point when you switch
cameras.
1. Replay the scene.
Press the A / B / C button or press the D / E / F button after pressing the Shift button.