Grass Valley K2 Dyno v.2.0 - Manual (Page 43)

14 June 2011 K2 Dyno Controller Operator Manual 43
Synchronizing playback status for Gang mode channels
It can also be used when you want to apply a mask-like effect by simultaneously
playing Key video with transparency information and Fill video you want to
composite to the Key video.
This section describes how to play Key and Fill video simultaneously using the gang
mode.
NOTE: You must store clips you want to use as Key and Fill video to the highlight
beforehand. For more information on how to use the Highlight screen, see
"Highlight" on page 53 .
1. In the Home screen, make sure that the controller is in gang mode.
• If the controller is in the on-air preview mode, the screen shows
"OnAirPreview". Switch to gang mode by pressing the PGM or PVW button
after pressing the Shift button.
2. Press the P1 button.
• The operation target channel is switched to the P1 channel.
3. Display the Highlight screen, and cue up the item you want to use as the Key video.
• For more information about the detailed operation procedures, see "Storing and
playing scenes in a highlight" on page 51 .
4. Adjust the playback start point of the Key video using the Jog knob.
5. Press the P2 button.
• The operation target channel is switched to the P2 channel.
6. Display the Highlight screen, and cue up the item you want to use as the Fill video.
7. Adjust the playback start point of the Fill video using the Jog knob.
• Adjust it according to the playback start point of the Key video you adjusted in
step 4.
8. Press the P1 and P2 buttons at the same time.
• The controller enters the Gang mode and the P1 and P2 buttons light up in red.
9. Press the Play button.
• The playback status of the Key and Fill video is synchronized.
• You can also perform a slo-mo playback with the T-Bar.
• To exit the Gang mode, press the P1 or P2 button.
Fill video
Key video