Grass Valley K2 Dyno v.2.0 - Manual (Page 42)

42 K2 Dyno Controller Operator Manual 14 June 2011
Chapter 3 Playback
6. Press the Take button.
The video that is put into standby in the preview channel is loaded and played in
the program channel. Even if the video is currently stopped in the preview channel,
it will be in a playback state at the same time as the
Take button is pressed.
7. To turn off the preview control, press the P1 button.
Switching the operation target channel in gang mode
This section describes how to switch the operation target channel in gang mode.
1. In the Home screen, make sure that the controller is in gang mode.
• If the controller is in gang mode, both P1 and P2 show in the Status Indicator
line of the Home screen.
• If the controller is in the on-air preview mode, the Status Indicator line on the
Home screen shows PVW or PGM. Switch to gang mode by pressing the PGM
or PVW button after pressing the Shift button.
2. Press the P1 or P2 button.
The operation target channel is switched to the P1 or P2 channel.The button for the
selected channel lights up in red.
Synchronizing playback status for Gang mode channels
You can synchronize the playback status for multiple channels by turning on the gang
mode.
For example, this function can be used when you want to play video from multiple
camera angles synchronizing them or when you want to show difference in speed
between two ski jumpers by synchronizing the video of the player A and player B
from the start point.
Program Channel Preview Channel