H3C Technologies H3C S12500 Series Switches - Manual (Page 69)

53
The output shows that Switch A has deleted the BFD session on VLAN-interface 100 to Switch C
and displays no output.
# Display the RIP routes of RIP process 1 on Switch A.
display rip 1 route
Route Flags: R - RIP, T - TRIP
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------------------
The output shows that the RIP route learned from Switch C no longer exists.
# Display RIP routes destined for 100.1.1.0/24 on Switch A.
display ip routing-table 100.1.1.0 24 verbose
Routing Table : Public
Summary Count : 1
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 2
Preference: 100 Cost: 2
IpPrecedence: QosLcId:
NextHop: 192.168.3.2 Interface: vlan-interface 300
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 192.168.3.2
Tunnel ID: 0x0 Label: NULL
BKTunnel ID: 0x0 BKLabel: NULL
State: Active Adv Age: 00h18m40s
Tag: 0
Troubleshooting RIP
No RIP updates received
Symptom
No RIP updates are received when the links work well.
Analysis
After enabling RIP, use the network command to enable corresponding interfaces. Make sure no
interfaces are disabled from handling RIP messages.
If the peer is configured to send multicast messages, the same should be configured on the local end.
Solution
1. Use the display current-configuration command to verify RIP configuration
2. Use the display rip command to verify whether some interface is disabled