Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 196
180
Figure 68 Network diagram
Configuration procedure
1.
Configure the IP addresses and subnet masks for interfaces. (Details not shown.)
2.
Configure IS-IS on the switches to make sure that Switch A, Switch B, and Switch C can
communicate with each other at layer 3 and dynamic route update can be implemented among
them with IS-IS. (Details not shown.)
3.
Configure IS-IS Graceful Restart:
# Enable IS-IS Graceful Restart on Switch A and configure the Graceful Restart Interval.
[SwitchA] isis 1
[SwitchA-isis-1] graceful-restart
[SwitchA-isis-1] graceful-restart interval 150
[SwitchA-isis-1] return
# Configure Graceful Restart on Switch B and Switch C in the same way as Switch A. (Details not
shown.)
4.
Verify the configuration:
After Switch A establishes adjacencies with Switch B and Switch C, they begin to exchange
routing information. Restart IS-IS on Switch A, which enters into the restart state and sends
connection requests to its neighbors through the Graceful Restart mechanism to synchronize the
LSDB. Using the display isis graceful-restart status command can display the IS-IS GR status on
Switch A.
# Restart the IS-IS process on Switch A.
Warning : Reset ISIS process? [Y/N]:y
# Check the Graceful Restart status of IS-IS on Switch A.
Restart information for IS-IS(1)
--------------------------------------------------------------------
IS-IS(1) Level-1 Restart Status
Restart Interval: 150
SA Bit Supported
Total Number of Interfaces = 1
Restart Status: RESTARTING
Number of LSPs Awaited: 3
T3 Timer Status:
Remaining Time: 140