Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 66

50
Switch A is connected to Switch C through Switch D. VLAN-interface 300 on Switch A runs RIP process
2; VLAN-interface 400 on Switch C, and VLAN-interface 300 and VLAN-interface 400 on Switch D run
RIP process 1.
Enable static route redistribution into RIP on Switch A and Switch C so Switch A and Switch C have routes
to send to each other. Switch A learns the static route sent by Switch C, the output interface is the interface
connected to Switch B.
When the link between Switch B and Switch C fails, BFD can quickly detect the link failure and notify it
to RIP, and the BFD session goes down. In response, RIP deletes the neighbor relationship with Switch C
and the route information received from Switch C. Then, Switch A learns the static route sent by Switch C,
with the output interface of the route being the interface connected to Switch D.
Figure 16 Network diagram
Device Interface IP
address
Device
Interface
IP address
Switch A
Vlan-int300
192.168.3.1/24
Switch B
Vlan-int100
192.168.1.2/24
Vlan-int100
192.168.1.1/24
Vlan-int200 192.168.2.1/24
Switch C
Vlan-int200
192.168.2.2/24
Switch D
Vlan-int300 192.168.3.2/24
Vlan-int400
192.168.4.2/24
Vlan-int400
192.168.4.1/24
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure basic RIP and enable static route redistribution into RIP so Switch A and Switch C have
routes to send to each other:
# Configure Switch A.
[SwitchA] rip 1
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 101.1.1.0
[SwitchA-rip-1] peer 192.168.2.2
[SwitchA-rip-1] undo validate-source-address
[SwitchA-rip-1] import-route static
[SwitchA-rip-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] rip bfd enable