Configuring bfd for bgp, Network requirements, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 281
265
[SwitchC] bgp 65009
[SwitchC-bgp] router-id 3.3.3.3
[SwitchC-bgp] peer 9.1.1.1 as-number 65009
# Enable GR capability for BGP.
[SwitchC-bgp] graceful-restart
4.
Verify the configuration:
Ping Switch C on Switch A. Meanwhile, perform an active/standby main board switchover on
Switch B. The ping operation is successful during the whole switchover process.
Configuring BFD for BGP
Network requirements
As shown in
,
•
Configure OSPF as the IGP in AS 200.
•
Establish two IBGP connections between Switch A and Switch C. When both links are working,
Switch C adopts the link Switch A<—>Switch B<—>Switch C to exchange packets with network
1.1.1.0/24. Configure BFD over the link. Then if the link fails, BFD can quickly detect the failure and
notify it to BGP. Then the link Switch A<—>Switch D<—>Switch C takes effect immediately.
Figure 95 Network diagram
Device Interface
IP
address
Device
Interface IP
address
Switch A
Vlan-int100
3.0.1.1/24
Switch C
Vlan-int101 3.0.2.2/24
Vlan-int200
2.0.1.1/24
Vlan-int201
2.0.2.2/24
Switch B
Vlan-int100
3.0.1.2/24
Switch D
Vlan-int200 2.0.1.2/24
Vlan-int101
3.0.2.1/24
Vlan-int201 2.0.2.1/24
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)