H3C Technologies H3C S12500 Series Switches - Manual (Page 314)

298
Task Command Remarks
Reset a RIPng process. reset ripng process-id process Available in user view.
Clear statistics of a RIPng process. reset ripng process-id statistics Available in user view.
RIPng configuration examples
By default, Ethernet, VLAN, and aggregate interfaces are down. Before configuring these interfaces,
bring them up by using the undo shutdown command.
Configure RIPng basic functions
Network requirements
As shown in Figure 104 , all switches run RIPng. Configure Switch B to filter the route (3::/64) learned
from Switch C, which means the route will not be added to the routing table of Switch B, and Switch B will
not forward it to Switch A.
Figure 104 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Configure Switch A.
system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 400
[SwitchA-Vlan-interface400] ripng 1 enable
[SwitchA-Vlan-interface400] quit
# Configure Switch B.
system-view
[SwitchB] ripng 1
[SwitchB-ripng-1] quit
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] ripng 1 enable
[SwitchB-Vlan-interface200] quit
[SwitchB] interface vlan-interface 100