H3C Technologies H3C S12500 Series Switches - Manual (Page 376)

360
Step Command Remarks
3. Enable logging of peer
changes globally.
log-peer-change
Optional.
Enabled by default.
For information about the log-peer-change
command, see Layer 3—IP Routing
Command Reference.
4. Enter IPv6 address family
view.
ipv6-family N/A
5. Enable the state change
logging for an IPv6 peer or
peer group.
peer { group-name |
ipv6-address } log-change Optional.
Enabled by default.
Controlling route distribution and reception
This task includes routing information filtering, routing policy application, and route dampening.
Configuration prerequisites
Before you configure route distribution and reception control, complete the following tasks:
• Enable IPv6 with the ipv6 command in system view.
• Configure IPv6 BGP basic functions.
Configuring IPv6 BGP route redistribution
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view or IPv6
BGP-VPN instance view. ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
4. Enable default route redistribution into
the IPv6 BGP routing table.
default-route imported
Optional.
Not enabled by default.
If the default-route imported
command is not configured,
using the import-route command
cannot redistribute an IGP default
route.
5. Enable route redistribution from
another routing protocol.
import-route protocol
[ process-id [ med med-value
| route-policy
route-policy-name ] * ]
Not enabled by default.